DO YOUR LIGHTS EVER FLICKER?  Do your lights ever flicker, go momentarily dim and then back to normal?  Do light switch controls feel warm to the touch? If yes, please read on.....

DID YOU KNOW?  When lights flicker erratically, a potentially serious problem is in the making.  If you notice lights dimming momentarily at the time that motor equipped appliances start up, you are experiencing what's known as a surge in your system.

PROBLEMS ON THE WAY:  Flickering lights as noted above, are produced by loose connections located somewhere in the related circuitry.  Loose connections can be a result of worn contact in outlets, light switches, or even loose wires at main connection points.  When loose connections are present, arcing takes place.  The arcing will burn away at contacts and in a short time enough of the contact or connecting wires will be burned away discontinuing the flow of electricity all together.  Along with the arcing, is the presence of heat build up.  Fires can be caused from the arcing and or the heating process.  Motor equipped appliances suffer due to the reduced amount of power or voltage.

WHAT SHOULD YOU DO?  If any of the symptoms noted above are common place, in your home, you should consider our "WIRE MAINTENANCE PROGRAM". 

PLEASE NOTE:  You should realize that the above conditions are early warning signs.  Don't wait until your power fails completely, or worse yet a fire breaks out.

OUR MAINTENANCE PROGRAM
To reduce your risk of electrical fires, ongoing maintenance expenses and replacement cost, of appliances, and electronic equipment we have a solution.

	We will perform a complete diagnostic inspection of the entire electrical system.
	Every light switch and plug/outlet will be removed, the wires will be inspected for signs of heat damage, deteriorating insulation, and excessive wear on contacts.  Any connections will be remade as needed.  Following these maintenance procedures a new device will be installed in your choice of ivory or designer white.
	Lighting fixtures will be removed and all connections will receive the above inspection. Upon completion your lighting units will be reinstalled or we can install you new provided lighting unit with no additional charge for assembly. (Sorry, ceiling fans not included.)
	Connection points (commonly known as splices) throughout the attic, crawl, basement and service panel will also undergo treatment.
	Safety ground fault protective outlets will be installed where required by code. Ground Fault Outlets reduce shock hazard in damp locations i.e. kitchens, baths, garages and outdoors.
	We will warranty your electrical system (areas related to our program only) for two full years.